So I installed some video editing software, did some updates, and then BAM!! I can no longer send email. Whenever I hit send I get an error from Microsoft Word saying “Interface not registered” but then there was the internet… and I found the solution…
Solution is here at the MS site
“You receive the “Interface not registered” error message when you try to send or to save an e-mail message to the Drafts folder in Outlook 2002
View products that this article applies to.
Article ID : 870707
Last Review : August 10, 2004
Revision : 1.0
SYMPTOMS
If you use Microsoft Word as your e-mail editor in Microsoft Office Outlook 2002, and you try to send e-mail messages or to save e-mail messages to the Drafts folder, you may receive the following error message:
Interface not registered
Or, you may experience the following symptoms:
“¢ You receive an error message.
“¢ The e-mail message is not sent.
“¢ The e-mail message is not saved to the Drafts folder.
CAUSE
This behavior occurs if the Ole32.dll file that is located in the %Windir%\System32 folder is not registered correctly in the registry.
RESOLUTION
To resolve this problem, register the Ole32.dll file. To do this, follow these steps:
1. Click Start, click Run, type the following command in the Open box, and then click OK:
Regsvr32.exe %Windir%\System32\Ole32.dll
2. In the RegSvr32 dialog box, click OK.”
In microsoft outlook, interface not registered = a most sucky error
A similar post and solution can be found here:
Microsoft Outlook Interface not registered error
Had same problem after installing Nero 8, used above info and it worked cheers.
THis worked great! Thanks!
Brilliant - worked straight away - even after my IT dept told me they had no clue and would need my laptop into the office! Quick search on the internet and sorted! Thank you so much x
Thanks heaps, you are a genius!!
Yeah, talk about a headache. I’m glad I could point you guys in the right direction.
thanks solve my problem
Thank you so much, it’s nice finding people so helpful, keep up the good work.
i am using the ole.dll file and register the file.file register successfully & problem is solved Thanks for given the solutions.
well i’ll be a monkeys uncle - it actually worked
Thank’s for u solution.